MCC MIIC-203 Uživatelská příručka stáhnout pdf (Strana 51)

by Host communication driver software, and are not visible at the application

program level.

The RTS/CTS protocol requires a serial port, cabling, and Host communication

driver software that supports the additional control signals.

Command: /F[0|1][CR] Flow Control [0 = XON/XOFF, 1 = RTS/CTS]

Response: * 'iPort/AFM Ready

Default Setting: XON/XOFF

C General Call Control

Enables or disables iPort/AFM response to I

C Bus General Call (Address x00)

messages.

Command: /G[0|1][CR] 'I

C General Call [0 = Disabled, 1 = Enabled]

Response: * 'iPort/AFM Ready

Default Setting: Enabled

Hex Only Display Control

Controls Hex Only (~00...~FF) output of Master or Slave received data.

When enabled, all received I

C message data bytes are displayed in Hex

(~00…~FF) format. When disabled, received I

C message data bytes representing

ASCII printable characters (x20...x7F) are displayed as their ASCII printable

character. Non-ASCII printable data bytes are always displayed in Hex (~00…~FF)

form.

Command: /H[0|1][CR] 'Hex Only Display [0 = Disabled, 1 = Enabled]

Response: * 'iPort/AFM Ready

Default Setting: Enabled

Set iPort/AFM’s Own I

C Slave Address

Sets iPort/AFM's own I

C Slave Address (Hex 2...FE). Subsequent I

C messages to

this address will cause iPort/AFM to become an active Slave device on the bus.

Command: /Ixx[CR] 'Set iPort/AFM’s Own I

C Slave Address

Response 1: * 'iPort/AFM Ready

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 70 71

Žádné komentáře

MCC MIIC-203 Uživatelská příručka Strana 51